Dishwasher

The most common cause is a faulty door lock or door switch/ The dishwasher detects that the door is unlocked and will not start the cycle. The problems can also involve insufficient wire contact between the keypad and the main board due to moisture or the defective start button. The main board is probably defective. If you have cockroaches in the house, they can also cause malfunctions: They live inside the dishwasher, and their droppings can cause short circuits on the main board, causing it to stop working. The most common cause is a lack of power due to a bad wire contact or a faulty circuit breaker. Give us a call – we will carry out a comprehensive diagnosis and uncover the cause of the fault.

The most common reason is an old door seal. During operation, splash water hits the door and water leaks out. Another reason is a defective water valve or water level switch. In certain cases, vibrations or long periods of operation can cause cracks in the drain or water inlet hose, leading to water leaks. In rare cases, mechanical damage may cause cracks in the plastic housing or the metal housing may rust. A water leak can severely damage your floor or furniture and result in an expensive renovation. Call us urgently – we will come and help!

In this case, it could be a problem with the heating element or the cut-off thermostat. It could be a simple repair – only some parts need to be replaced. However, in many modern dishwashers, the circulation pump is responsible for drying the dishes, as the heating element is built into it and the whole part should be replaced. Therefore, such repairs are also more expensive. Another reason is a defective air pump that pumps the hot, humid air out of the dishwasher during the drying cycle, and the full diagnosis is a must to determine the exact cause of the malfunction. We know how to perform an optimal diagnosis and will help you repair your appliance!

The problem can be caused by both mechanical and electronic aspects. The coarse filter is often clogged or fragile glasses break when the dishwasher is loaded incorrectly and block the drain pump. In certain models, the soft filter screen can be damaged and food residues also block the drain pump. Sometimes the drain pipe is kinked and the water becomes blocked, causing an operating error and interrupting the process. In certain cases, the drain pump burns out and the control board malfunctions. The pressure switch may also be defective. If your dishwasher is not draining water, it is faulty. Give us a call and we will repair it.

There are several reasons for this: Circulation pump malfunction, clogged detergent nozzles, faulty soap dispensers and other likely problems. To find out the exact cause of the problem, give us a call and we will check the system and repair it.

It is possible that the broken glass touched the propeller of the drainage pump or the sprinkler system. However, it is much more likely that it is a noise from worn bearings in the circulation pump or the drain pump. Do not let your dishwasher break down completely – give us a call.

It could be a broken or blocked water valve. A kinked water hose or very low pressure in the water system can also cause the problem. A full diagnosis will reveal the cause of the fault and help to rectify it.